1、 Product function
The product could achieve short-range radio transmission by magnetic induction, applicable to charging for digital products of 5V/1A, communications, furniture, fire protection, water proof and other digital products, this product meets Qi wireless charging standard, compatible with all Qi enabled devices, and support fast wireless charging.
This product has wide operating voltage (DC 5V-9V-12V) which can adapt to most USB-A adapter and QC2.0 or 3.0 adapter.
How to use: Connect the adapter through Micro USB cable (standard cable). It maximum support 5W loads under normal charging mode when connect to 5V output adapter. And it maximum support 15W loads under fast charging mode when connect to QC2.0 or 3.0 adapter.
Disinfection mode: short press once to start the 18 minute fast mode, and short press twice to start the 30 minute standard mode. When the disinfection is completed, the indicator light goes out and the buzzer rings three times. Press and hold the button for more than 3 seconds and release the button after the buzzer rings to exit the disinfection mode.
Standby: Standby red light; 30 seconds off . Charging: The red light is straight.
FOD/Charging abnormality: Indicator light flashing red
Disinfection indicator: red and green mixed light is on, indicating wireless charging & 18min disinfection mode is carried out at the same time.
Disinfection indicator: red and green mixed light is on, indicating wireless charging & 18min disinfection mode is carried out at the same time.
Mobile phone charging status：When charge Samsung S6 edge, S6 edge+, Note 5, S7,S7 edge, S8, S8+, S9, Note8,When the phone is fully charged, if the phone is not removed away for a long time, the wireless charger will provide a low current input to keep the phone at 100%(Trickle charging).
2、 Receiver Placement
Kind Remind: The greater deviation distance, The lower charging efficiency The phone receiver coil center should be place in the center of transmitter, allowed distance is (± 2.5mm), If over this range, the transmitter will not work. It needs to put the phone in the correct position and the device will enter the charging status.
3、Basic Performance Parameters
transmitter for the mobile phone
Software version: IP6806-10W
Disinfection of
software version:ST Solutions
4、 ElectricCharacteristics
5、 ReliabilityRequirements
| Test Items | Test Conditions |
| Storage at high temperature test | +60℃ 4Hrs |
| Storage at low temperature test | -20℃ 4Hrs |
| Operating at high temperature | 40℃ 8Hrs |
| Operating at low temperature | -10℃ 8Hrs |
| High/low temperature circle tests | 45℃(2Hrs)-10℃(2Hrs)- 45℃(2Hr)-10℃
(2Hrs) |
Aging test: 5V, aging test for 2 hours; 9V, aging test for 2 hours; 12V, aging test for 2 hours；full load aging test. Normal temperature 25℃±3℃, aging test with LED indicator.
6、Automatic protection function
When the transmitter detected its connector’s load current is too large (current exceeds the rated output), the transmitter will shut off with the mobile receiver connection automatically, safety protection automatically.Put the mobile phone in correct position again after move the mobile 5 seconds later. It will re-enter charging status when the connection is successful.
7、 Execution Standards (Compatible with these specifications)
WPC1.2.4_Qi Standards/WPC 1.2.4_Qi,CE,FCC,RoHS.
Note : All test data is referenced to 25℃ ambient.
8、 Product picture
| Type | /White |
| Size | Φ=207mm，H=61mm |
| Weight | 300g |
9、 Product packing picture
